Eurofase Integrated Heating — Lutron, Control4 & Crestron

About this collection

Plan Eurofase electric infrared heating systems for multi-zone projects, Lutron RadioRA 3 environments and other professionally integrated controls. This category is for engineered heating architectures: heater hardware, switching, proportional control and electrical load handling must be specified as a complete system.

Outdoor heating for Lutron HomeWorks, RadioRA, Control4 and Crestron projects

Eurofase explicitly identifies Lutron, Control4 and Crestron as compatible professional automation platforms in its Universal Relay Control Box information. Integrators can design independent heater zones around an appropriately specified Eurofase load-control box and a verified compatible external control interface. This is a hardware/control-signal pathway, not a promise of a native software driver or a plug-and-play connection.

Match control behaviour first: EFCB24 supports separately engineered on/off switching; EFURCB24 provides manufacturer-described proportional 0–10 V heat control when paired with the correct signal source. Manufacturer naming of Lutron, Control4 or Crestron for EFURCB does not itself verify any specific dimmer module, EFCB controller or project wiring. Confirm zone loading, source/sink requirements, safe shutdown and approved wiring with Eurofase and the qualified installer. For the independent manufacturer app route, see Eurofase Smart Wi-Fi Patio Heating.

Choose between on/off and proportional control

  • EFCB24 contactor control boxes: manufacturer control-box family for defined on/off heating zones. Compare the exact M1–M4 zone-count variants against the project design.
  • EFURCB24 universal relay control boxes: project-led proportional / 0–10 V control family; M1–M6 models provide one to six zones subject to approved wiring, sourcing/sinking interface requirements and the capacity per zone.
  • C-Series high-temperature whips: 3-wire connection products for eligible control-box designs. These must not be assumed interchangeable with the standard 4-wire flush-mount whips.

Where the heater system starts

BUNDLE13 establishes a dual-EF60 recessed hardware path with controls selected separately. The individually sold EF40, EF50 and EF60 families can support separately engineered projects. LP40 is a distinct low-profile design and should not automatically receive the same mounting or controls. For additional mounting components, review Eurofase recessed patio heating.

RadioRA 3 is the signal/control layer—not the heater power circuit

The Lutron LMJ-5T-DV-B 0–10 V RF module has documented Lutron RadioRA 2 and RadioRA 3 support, and Eurofase's earlier RadioRA 2 guidance illustrates its use with EFURCB. This provides a component-level control-signal pathway for a compatible Eurofase EFURCB design. This is a conceptual architecture, not an approved electrical wiring diagram. Confirm signal behaviour, interface wiring, control-box input requirements, switching/isolation, amperage, zoning and all protection with Eurofase and the licensed installer. A Lutron control module must never be assumed to carry the heater load.

Project information for correct sizing

Provide the heater models and quantities, available service voltage, physical heater and control-box locations, intended independent zones, mounting type, desired scene behaviour and installation drawing. Do not order control-box hardware solely from the number of rooms or outdoor areas.

See Eurofase heating controls and zoning, Eurofase installation resources, and Lutron RadioRA 3 module documents.

Need help with a complete heating project? Use the Eurofase Heating Dealer Specification Guide for heater, mounting and control planning, and to reach Project Desk with your project requirements. Check the current manufacturer documents and have the installer verify the final electrical and ceiling design.